Skip to main content
Documentation menu

Set up work stations

This guide adds the stations at one of your locations and connects them to your work order templates, so every new work order is assigned to a station that can do it. Read Work stations first if you want the full picture of how assignment works.

Before you start

You need:

It helps to write down your stations and what each one does before you start. A list like “Laser 1: engraving. Laser 2: engraving. Table A: sewing, upholstery” turns straight into tags.

Step 1: Add your stations

  1. In Orderkraft, go to Settings → Locations.
  2. Click the location where the work happens.
  3. In the Work stations section, click Add work station.
  4. Give it a name people on the floor will recognise, like Laser 1 or Sewing table A, and click Save.

Repeat for every station at this location.

Step 2: Tag each station

  1. Open the station from the Work stations section on the location page.
  2. Under Tags, choose an existing tag or pick New tag… to create one.
  3. Add a tag for each kind of work the station can do.

Name tags after the work, not the machine: engraving, not laser. The same tag goes on your templates in the next step, and it should read naturally there too.

Step 3: Tag your work order templates

  1. Go to Settings → Work order templates and open a template.
  2. Under Routes to work stations tagged with, click Add tags.
  3. Tick the tags of the stations that can do this work, or type a new one and add it.

A template with no tags doesn’t route anywhere. Its work orders are created without a station, and you assign them by hand.

Step 4: Check it works

Assignment happens when a work order is created, so existing work orders keep the station they had (or none). To check your setup, create a new manufacturing order for a product whose plan uses one of the templates you tagged, or wait for the next order to come in.

Open one of its work orders. The station shows in the top right corner of the card. If it’s empty, check that:

  • The station is at the same location as the manufacturing order
  • The station and the template share at least one tag

To assign the work orders that were already there, open each one and choose Change work station from the … menu.

What’s next

  • Filter the Work orders list by Work station to see each station’s queue
  • Set up the manufacturing board for an overview of every order across your process